Main Electronics Finished

I have now finished the main electronics which including the on/off switch, emergency stop, and power supply operation button. These are now all embedded into the casing of the machine and have been fully tested. There is still quite a bit to do in this area, I need to add limit switches and pause and resume buttons but I have the machine in a state that I can start the adventure of learning how to operate the machine and begin my first projects. Below you can see the electronics in the main compartment along with my notes showing a rough wiring diagram along with notes of how to convert a standard PC ATX power supply into a power unit for the CNC machine.


View this post on Instagram

A post shared by mangojelly (@mangojellysolutions) on


View this post on Instagram

A post shared by mangojelly (@mangojellysolutions) on


View this post on Instagram

A post shared by mangojelly (@mangojellysolutions) on

Be the first to comment

Leave a Reply

Your email address will not be published.


*