Learning FreeCAD Part 3: G-Code And The First Cut

And the results are in! The cut was made at a Feed rate of 100 mm/min (seen in the grbl file as the G Code command F100 after each G1 command) With a max cut depth of 1.5mm with each pass so I was just nibbling away at the material. This was too slow for me so I will be upping the speed by a factor of 4. I was using a zig-zag cut which left some tool marks, will need to experiment with the other types of motion to see the types of finish.

Instagram link needed

Be the first to comment

Leave a Reply

Your email address will not be published.


*